Protection against spam bots. Please answer the following question: What year is it this year?
116 results found:

Boat Motor Mounting Kit
The boat motor holder allows the motor to be mounted on INTEX boats. It is important to know its dimensions and to take into account that the mounts are fixed on the boats and cannot be purchased separately.

Cordless vacuum cleaners
With cordless pool vacuums, it is important to know a few basic points. The pool vacuum cleaner only works in water, the microfilter should be fitted inside the black mesh and always point the head upwards when removing the vacuum cleaner, otherwise dirt will leak out.

Deluxe wall mount skimmer
The Deluxe Skimmer is used to capture debris from the pool surface and is compatible with various types of INTEX pools. Proper installation includes attachment to the pool structure and connection to the filter pump. The skimmer improves the cleanliness of the surface, but it is advisable to disconnect it in time for full filtration.

Installation auto pool cleaner for model 28001, ZX300 - 28005
Proper connection to the inlet with the water flow going back into the pool is essential for proper operation of the pool vacuum. Full hose immersion and hose connection compatibility is also important - smaller diameter requires an adapter.

Installation auto pool cleaner for model ZX50 - 28007
The ZX50 pool vacuum model works on the principle of pump suction power and requires a connection to the pool outlet. It is important to follow the correct sequence of steps - submerging the hoses, connecting to the correct grommet and ensuring the correct water flow to start the unit.

No or low water flow of the solar mat
Low or no water flow when using solar heating is usually due to higher resistance in the circuit. Recommended practice includes removing excess fixtures, proper venting and optimizing valve settings for multiple solar panels connected.

Solar mat
The correct procedure must be followed when connecting the solar heating system. The maximum pump flow is 5678 l/h and the heating must not be above the water level. If you are connecting several heaters in succession, open the valves sequentially. Aerated filtration and too many accessories in the circulation circuit reduce the water flow.

Test strips
Test strips measure chlorine levels, pH, alkalinity and water hardness. The pH should be between 6.8 and 7.6, alkalinity between 60 and 120 ppm, and free chlorine between 2 and 4 ppm. Submerge the entire strip in water, remove and allow to lie horizontally. After 15 seconds, read the water values.

Transom Motor
The transverse marine electric motor requires a traction or semi-traction battery, ideally gel or AGM. The recommended battery capacity is 65-75 Ah, allowing operation for up to 5 hours at lower speeds. The charger should have switching between battery types or automatic charge cycle control.

After installing the hanging skimmer and connecting it to a filter pump, the skimmer will start to vibrate and protrude from the water surface. What should I do?
Make sure the skimmer hose is perfectly connected from the pool to the filter pump. Place the hook (for Easy Set pools) on the top inflatable ring or tighten the screws (Metal Frame pools). Pay special attention to ensure that the hook does not pierce the inflatable ring of Easy Set pools. Check for air in the pump, skimmer or water circulation system. If necessary, bleed the system.